The processing procedures of the machining center and the traditional machine tool are generally the same. The main difference is that the machining center completes all the cutting processes through one-time clamping and continuous automatic machining. Therefore, the machining center needs to carry out some "aftermath work".

1) Cleaning treatment: after the machining center completes the cutting task, it is necessary to remove the chips in time, wipe the machine body, and keep the machine tool and the environment clean.

2) Inspection and replacement of accessories: first of all, pay attention to check the oil wiper plate on the guide rail, and replace it in time if it is worn; check the state of lubricating oil and coolant, and replace it in time if it is turbid, and add water if it is lower than the scale water level;

3) The shutdown procedure should be standardized: the power supply and the total power supply on the machine tool operation panel should be turned off in turn; in the absence of special circumstances and special requirements, the principles of first return to zero, manual, jog, and automatic should be followed; (the operation of the machining center It should also start at low speed, medium speed, and then high speed, and the running time at low speed and medium speed should not be less than 2-3 minutes, and start working after there is no abnormal situation)

4) Standardized operation: Do not beat, straighten, or modify the workpiece on the chuck or at the top, and the next operation must be confirmed after the workpiece and the tool are clamped; the safety and safety protection devices on the machine tool must not be disassembled and moved arbitrarily; efficient Processing is actually safe processing. As an efficient processing equipment, the operation of the processing center must be reasonable and standardized when it is shut down. It is not only the maintenance of the current completed process, but also the preparation for the next start.